26. junio 2013

The Ha-VIS preLink® Extender enables cable extension for up to 10Gbit/s network cabling

Ha-VIS preLink® Extender

The Ha-VIS preLink® Extender permits the easy extension of transmission paths. The solution also allows unused cables to be reactivated and extended until the next required connection. The structured cabling run can be used for applications up to 10 Gbit/s and up to the maximum link length

HARTING’s successfully introduced Ha-VIS preLink® technology is now complemented by another product, the Ha-VIS preLink® Extender. This component of the innovative Ha-VIS preLink® cabling system enables the simple extension of transmission paths in data network cabling. In addition, it allows fire zones to be bridged and subscriber ports to be directly connected to the terminal block connector without the need for intermediate patching.

Even unused cables can be reactivated and extended to the next required connection. The installer simply assembles the Ha-VIS preLink® termination module onto both ends of the cable to be extended. The terminated cable ends are then inserted into the Ha-VIS preLink® Extender. A flexible shield clamp transmits the cable shield potential. The Extender itself can be directly mounted on walls, in cable ducts or in a switch cabinet via two Ø 3.2 mm fixing holes. The small 15.6 x 13.2 x 65.7 mm  (W x D x L) design permits installation even in cramped spaces.

The Ha-VIS preLink® Extender meets the transmission performance specifications for Category 6A pursuant to ISO/IEC 11801 Ed. 2.2 (2011-06). As a result, the structured cabling run can be used for applications up to 10 Gbit/s, up to the maximum link length.

Available Downloads:

Ha-VIS preLink® Extender

page from the catalogue "HARTING News 2013"

PDF

147 K download